In addition to the piece shown below, you will need the following pieces:
4 1/4" x 5 1/2" backing piece
1 1/2" x 3 3/4" sliding message piece (you can vary the width and the length can be as short as 3 1/4" and still work find in the slider) - score one end of the piece at 1/2"
1" x 4 1/2" & 1" x 3" for the T-Slide mechanism pieces
The assembly instructions are the same as my standard T-Slide. When cutting your slot for the sliding message, make sure that the top of the slot is 1/2" from the score line. One of my readers suggested using the word window punch to create the slot. This works perfectly if you line up the bottom of the word window about 1/8" above the score line. Thanks for the suggestion, KT Hom.
You can click on the photo for a bigger view. If you have any questions, please let me know.
4 comments:
Oh I saw your tutorial on SCS! Congrats!
Debbie from Salem I as well saw your tutorial on SCS. I was so excited to see it for I have been following your blog on this as well. Great job and thank you for sharing
Oh thank you thank you for this. I want to try this card this afternoon and this will be a BIG help. Love your blog BTW, you are an amazing paper crafter.
Hugs,
Joani
Thank you for the diagram of T-slide. Thanks again for the instruction from SCS. You did a good job. Keep up good work
Post a Comment